Дупликаторы Ricoh Priport VT-2250 (C224)
| Код ошибки | Неисправность | Возможные причины | |||
| E 01 | Malfunction in the cutter section: The cutter does not reach both right and left cutter position switches within 2 seconds
| 1) Drive wire cut 2) Drive section malfunction 3) No power supply | |||
| E 02 | Malfunction in the paper table drive section: The lower limit sensor or the paper table height sensor status does not change even though the paper table Up or Down signal is applied | 1) Drive worm gear broken 2) Mounting screw of the worm gear broken 3) No power supply | |||
| E 04 | The temperature of the thermal head or the power supply unit is high: The temperature of the thermal head becomes greater than 53°C | 1) Defective thermistor 2) Defective thermal head 3) Defective power supply unit | |||
| E 05 | Malfunction in the image shifting section: All the encoder output signals are at the "H" level | 1) Encoder connector of the image shifting section is disconnected 2) Defective encoder | |||
| E 06 | Mechanical lock: The drum rotation sensor detects that the drum rotation speed is abnormal | 1) Mechanical lock 2) Main motor failure | |||
| E 09 | Malfunction of the thermal head | 1) Defective thermal head 2) Defective thermistor 3) Thermal head harness broken | |||
| E 10 | Malfunction in the thermal head drive section | 1) Defective main control PCB 2) Thermal head drive wire short circuit | |||
| E 11 | Image shift motor malfunction: The encoder status does not change within 3 seconds after the encoder motor starts rotating | 1) Image shift motor lock 2) Image shift motor harness broken | |||
| E 12 | Malfunction in the pressure plate drive section: The loner pressure plate sensor is not actuated within 8 seconds. The upper pressure plate sensor is not actuated within 4 seconds | 1) Pressure plate motor lock 2) Pressure plate motor harness broken 3) Pressure plate position sensor malfunction |
