Код ошибки
|
Описание
|
C2
|
Transfer corona problem or HVT
|
CC
|
Original detection problem.
|
CH
|
Door open or developer unit not installed, not connected properly, or not latched in place properly.
|
F1
|
Sub code 00: Communication error between main board and sorter. 01: Jogger error. 02: Sorter transport motor drive. 04: Sorter bin sensor problem. Lower limit sensed wrong.
|
F2
|
Sub code 02: Toner motor problem. 31: Image density sensor problem. Could be a problem with the light level. 32: Drum mark sensor problem. Does not see mark on drum or sensor does not work properly. 35: Grid voltage correction will not work during simulation.
|
F3
|
Sub code 12: Copier upper cassette lift motor problem. Copier bottom cassette lift motor problem.
|
H2
|
Fuser thermistor open.
|
H3
|
Fuser temperature too high.
|
H4
|
Fuser temperature too low. Lamp, thermal switch, connections.
|
L4
|
Sub code 01: Drive problem, main motor, sensor, bind.
|
L5
|
Sub code 03: Drive problem with 4th/5th mirror assembly, motor, sensor, board.
|
L8
|
Sub code 01: Power frequency problem.
|
PC
|
Card counter or key counter not installed.
|
PF
|
There is an inhibit command from the PC modem. This is reset with simulation 17.
|
U2
|
Sub code 00 or 01: Memory error.
|
U3
|
Sub code 20: Mirror motor locked. 21: Mirror motor home sensor.
|
U4
|
Sub code 02: Duplex alignment plate out of position motor, cable, sensor.
|
U5
|
Sub code 00: Communication problem between main board and RADF. 01: RADF motor drive problem. 02: RADF motor drive problem. 03: RADF resist sensor. 04: RADF exit sensor.
|
U6
|
Sub code 00: Communication error between copier and desk. 01, 02, 03: Desk lift motor drive problem. 08: Desk 24v problem. 09: LCT motor overload. 10: Desk transport motor drive problem.
|
U7
|
Sub code 00: Communication problem between copier and PC modem.
|
